E-Bike 36V Service Manual download pdf (Page 48)

8-1

CONNECTOR IDENTIFICATION

All electrical components in the E-Bike

connect to the controller, which is mounted

between the side covers. Refer to Figure 1.

RIGHT SIDE COVER

Removal

1. Open the door to the battery compartment.

2. Remove the three rubber plugs from the

right side cover holes. Note that the small plug

goes in the lower hole.

3. Remove the three side cover screws. The

screw from the lower hole is smaller than the

two upper screws. It will have to be reinstalled

in the same location.

4. Lift the side cover from the E-Bike

5. If necessary, remove the cable inlet cover

(A, Figure 2) from the left side cover. Pull the

cable inlet cover forward and around the head

tube until the tabs clear the left side cover .

Installation

1. If removed, install the cable inlet cover into

the left side cover. Slide the tabs of the cover

(A, Figure 2) onto the tongues of the side

cover. Gently push cable inlet cover so it fol-

lows the side-cover contour around the head

tube and rests in place in the left side cover.

Controller Board Connectors

Reference Number Component/Function Connector Type

A 5 amp fuse

B Accessory control (left side) 6-pin

C Throttle control (right side) 7-pin

D Brake sensor, right 2-pin

E Brake sensor, left 2-pin

F Taillight 4-pin

G Horn (1 red and 1 black wire) 3-pin

H Headlight (1 white and 1 black wire) 3-pin

Controller

FIG. 1

Chapter Eight

ELECTRICAL

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 60 61

No comments

E-Bike 36V Service Manual Page 48