E-Bike 36V Specifications download pdf (Page 14)

WARNING:

Keep the charger and battery pack away from water to

prevent electrical shock an shorting. The charger is intended

for indoor use only.

CAUTION:

Be sure the cooling fan vent is unrestricted or facing out

when charging the battery to prevent the charger from over-

heating. The cooling fan should always be on when the red

LED is on to prevent charger overheating.

Remote Battery Power Pack Charging

The battery pack can be removed for remote charging.

1. Turn the power knob to the OFF position.

2. Open the battery-compartment door.

3. Release the retainer gate latch.

WARNING:

The battery pack weighs over 20 pounds. Use both hands to

remove or install it. Reinstall the battery - pack by tilting the

bottom first.

4. Grasp the power-pack handle with one hand. Pull the

battery pack from the battery compartment while

supporting the bottom of the power pack with your free

hand as shown in Figure 4.

5. Set the power pack on a bench so the side with the fan

faces up and the handle is on the side.

6. Retrieve the charging cord located in the compartment

above the bottom bracket.

7. Plug the female end of the cord into the receptacle on

the side of the battery charger and the male end of the

cord into a standard U.S. 110V/60 cycle wall socket.

8. The red LED and cooling fan will automatically turn on

when in the charging mode.

FIG.4

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 48 49

No comments

E-Bike 36V Specifications Page 14