E-Bike 36V Specifications download pdf (Page 18)

d. Suspension Seatpost Adjustment

On models equipped with a suspension seatpost, the preload

and saddle side-to-side can be adjusted to suit your

preferences.

1. To adjust the preload, perform the following:

a. Release the QR release and remove the seatpost

from the frame.

b. Use a 6 mm Allen wrench to turn the preload adjuster

at the bottom of the suspension seatpost. See Figure 8.

Turning the adjuster clockwise increase the

preload, which stiffens the suspension. Turning the

adjuster counterclockwise decreases the preload,

which softens the suspension.

c. Insert the seatpost into the frame, and adjust the seat

height as described above.

2. Turn the side-to-side adjuster (A, Figure 7) in or out to

adjust the amount of side-to-side play at the saddle tip.

Handlebar height and angle

On the E-Bike™, you can raise or lower your handlebars a bit

by adjusting stem height. Loosen the stem binder (Figure 9)

bolt by turning it counterclockwise three or four full turns. If

the bolt rises but the stem doesn't, get a piece of wood or a

soft mallet and give the bolt a good whack to release the

wedge. Adjust the stem position as desired, align stem with

the tire, and retighten the binder bolt tight enough so that you

cannot twist the stem and handlebars out of alignment. Under

no circumstances should the stem be retightened with its

minimum insertion mark or maximum extension mark visible.

Check to make sure that the handlebars rotate freely in both

directions without the brake cables catching or binding on

anything.

FIG. 8

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 48 49

No comments

E-Bike 36V Specifications Page 18