E-Bike 36V Specifications download pdf (Page 13)

• The charger can remain plugged-in for trickle-charge

purposes during long periods of storage.

• For storage periods over 3 months, the battery pack

should be checked and fully recharged every 3 months.

• A battery charger is located at the top of the battery

pack. The battery can be charged when the battery is

on-board the E-Bike™ or it can be removed for remote

charging.

On-Board Battery Charging

Perform the following to charge the battery while the battery

pack is installed in the E-Bike™.

1. Turn the power knob to the OFF position.

2. Turn the battery-compartment latches clockwise, and

open the door.

3. Retrieve the charging cord from the compartment above

the bottom bracket.

4. Plug the female end of the cord into the receptacle on

the battery charger as shown in Figure 3. Plug the male

end of the cord into a standard U.S. 110V/60 cycle wall

socket.

5.The red LED on the charger and cooling fan will

automatically turn on when in the charging mode.

6. The LED turns to green and the cooling fan turns off

when the battery pack is fully charged.

WARNING:

Keep the charger and battery pack away from water to

prevent electrical shock and shorting. The charger is

intended for indoor use only.

CAUTION:

If the cooling fan does not operate when in the charging

mode (Red LED on), immediately unplug the charger from

the wall socket. Contact an authorized EVG dealer for advice.

FIG.3

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 48 49

No comments

E-Bike 36V Specifications Page 13