E-Bike 36V Specifications download pdf (Page 27)

Installing a Quick Release Front Wheel

1. Rotate the quick-release lever so that it curves away from

the wheel (Figure 12). This is the OPEN position.

2. With the steering fork facing forward, insert the wheel

between the fork blades so that the axle seats firmly at the

top of the fork dropouts (the slots at the tip of the fork blades).

The quick-release lever should be on the left side of the E-

Bike™ (Figure 12).

3. Hold the quick-release lever in the OPEN position with

your right hand, and tighten the tension adjusting nut with

your left hand until it is finger tight against the fork dropout

(Figure 12).

4. While pushing the wheel firmly to the top of the fork

dropouts, and at the same time centering the wheel rim in the

fork, rotate the quick-release lever upwards and push it into

the CLOSED position (Figure 12). The lever should be

parallel to the fork blade and curved toward the wheel.

CAUTION:

If you can fully close the quick release without wrapping your

fingers around the fork blade for leverage and if the lever

does not leave a clear imprint in the palm of your hand, the

tension is insufficient. Open the lever, turn the tension

adjusting nut clockwise a quarter turn, and then try again.

5. If the lever cannot be pushed all the way to a position

parallel to the fork blade, return the lever to the OPEN

position. Then turn the tension adjusting nut

counterclockwise one-quarter turn, and try tightening the

lever again.

6. Close the brake pads. Spin the wheel to make sure that it

is centered in the frame and clears the brake pads.

Removing a Bolt-On Rear Wheel

1. Open the rear brake pads.

2. Shift the rear derailleur to high gear (the smallest rear

sprocket).

3. With a 15 mm box wrench or a six-inch adjustable wrench,

loosen the two axle nuts (Figure 13).

4. Remove the motor torque arm bolt from the left side seat

stay above the drop out.

5. Disconnect the motor QR-connector and temperature-

sensor connector in the QR housing on the inside of the left

seat stay above the motor torque arm bolt.

FIG.12

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 48 49

No comments

E-Bike 36V Specifications Page 27